Editing Módulo HM-10
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 38: | Line 38: | ||
void setup() { | void setup() { | ||
Serial.begin(9600); | Serial.begin(9600); | ||
+ | |||
// If the baudrate od the HM-10 module has been updated you may need to change 9600 by another value | // If the baudrate od the HM-10 module has been updated you may need to change 9600 by another value | ||
// Once you have found the correct baudrate you can update it using AT+BAUDx command (AT+BAUD0 for 9600 bauds) | // Once you have found the correct baudrate you can update it using AT+BAUDx command (AT+BAUD0 for 9600 bauds) |